31
edits
Difference between revisions of "UPS Monitoring (APC) via SNMP"
UPS Monitoring (APC) via SNMP (view source)
Revision as of 16:10, 8 December 2012
, 16:10, 8 December 2012no edit summary
| Line 1: | Line 1: | ||
= UPS(APC) Monitoring Basics = | = UPS(APC) Monitoring Basics = | ||
You can monitor UPS devices via SNMP if you have installed [http://www.apc.com/products/family/index.cfm?id=98&tab=models#specs network | You can monitor UPS devices via SNMP if you have installed [http://www.apc.com/products/family/index.cfm?id=98&tab=models#specs network management card] into your UPS. | ||
After installing and configuring your | After installing and configuring your management card, add new node into netxms and create these DCI. ''Don't forget about instane (.0 on the end of each OID)'' | ||
= DCI = | = DCI = | ||
| Line 56: | Line 56: | ||
Netxms have power.mib by default. New version of this mib you can find in apc site. | Netxms have power.mib by default. New version of this mib you can find in apc site. | ||
= SNMP traps = | = SNMP traps = | ||
For | For using traps you need configuring you network managment card, you can do this via card web interface. | ||
[http://www.netxms.org/forum/general-support/sharing-standard-templates-for-netxms/ Here] you can find traps templtate for apc devices for netxms. | [http://www.netxms.org/forum/general-support/sharing-standard-templates-for-netxms/ Here] you can find traps templtate for apc devices for netxms. | ||
[[File:Apc_add_trap_rec.png|thumb|right]] | [[File:Apc_add_trap_rec.png|thumb|right]] | ||